- Flathead screwdriver
- Phillips head screwdriver
- Socket wrench set
- Pliers
- New window regulator assembly
1. Disconnect the battery. This will help to prevent any electrical accidents while you are working on the window regulator.
2. Remove the door panel. You will need to remove the following screws and bolts:
- Two Phillips head screws located at the top of the door panel
- One Phillips head screw located at the bottom of the door panel
- Two 10mm bolts located on the side of the door panel
3. Remove the water shield. The water shield is a plastic sheet that protects the window regulator from moisture. To remove it, simply pull it off the door frame.
4. Remove the window regulator assembly. The window regulator assembly is attached to the door frame by four bolts. Remove these bolts and then lift the window regulator assembly out of the door.
5. Install the new window regulator assembly. Place the new window regulator assembly into the door and then reinstall the four bolts.
6. Reinstall the water shield. Reinstall the water shield by pushing it back onto the door frame.
7. Reinstall the door panel. Reinstall the door panel by aligning it with the door frame and then reinstalling the screws and bolts.
8. Reconnect the battery. Reconnect the battery and then test the window regulator to make sure that it is working properly.
