1. Turn ignition to On.
2. Press and hold the HomeLink 1 or 2 button for about 20 seconds, until the indicator light blinks rapidly.
3. Release the button.
4. Press and hold the HomeLink 1 or 2 button again, this time for about 30 seconds, until the indicator light changes to a solid state.
5. Release the button.
6. The HomeLink system is now reset and ready to be programmed with a new remote code.
To program a new remote code into the HomeLink system:
1. Park your Odyssey within range of the garage door opener.
2. Press and hold the HomeLink 1 or 2 button and the remote control button simultaneously, until the indicator light blinks rapidly.
3. Release both buttons.
4. The remote code is now programmed into the HomeLink system.
Note: If you have a multi-code remote control, you may need to repeat steps 2-4 to program each individual code.
