Auto >> AutoSPT >  >> Auto Repair

How do you remove the distributor in a 1991 Toyota Camry?

To remove the distributor in a 1991 Toyota Camry, follow these steps:

1. Disable the ignition.

2. Remove the distributor cap.

3. Disconnect the distributor wires.

4. Remove the distributor housing bolts.

5. Lift the distributor out of the engine.

6. Remove the o-ring from the distributor.

7. Clean the distributor housing and the o-ring.

8. Apply grease to the o-ring.

9. Reinsert the distributor into the engine.

10. Reinstall the distributor housing bolts.

11. Reconnect the distributor wires.

12. Reinstall the distributor cap.

13. Enable the ignition.

*Note: The distributor may be difficult to remove due to rust or corrosion. If you are unable to remove the distributor by hand, you may need to use a puller.*

Auto Repair
What tool is needed to remove the oil drain plug on a 1988 Pontiac fiero? How can you reset your alarm on a 1999 Lincoln town car without the key fobs?
Car Care
Why would my car almost stall when idling? My Engine Sounds Loud When Accelerating. What’s Going on? Where can i get owner manuel for a 1987 komfort 31 motorhome?
Engine
What do you need for a tuneup engine tune-up on 1998 Chevy blazer? If i started my 1999 Chevy Tahoe moved it ten feet then turned off. What could keep from starting again after about 10 minutes of just sitting. engine turns over but will not start.?
Electric Car
Did the 71 Chevy custom 100 with a 307 have points or HEI? Where can one buy a Yamaha Raptor 660? Where is the cabin air filter located on a 2007 Chevy Malibu?
Autopilot
What styles does the Harley Davidson watches come in? What does the A1 code for 2006 Honda odyssey mean?
Car Photos
Is shrink wrapping a car vandalism? If you build one good car out of two junk cars what vin do use? What signs should you look out for with a 2003 330xi BMW?