Auto >> AutoSPT >  >> Auto Repair

How do you disable the seat belt alarm for 2008 mercury mariner?

To disable the seat belt alarm for a 2008 Mercury Mariner, follow these steps:

1. Turn the key to the "On" position. Do not start the engine.

2. Fasten your seat belt.

3. Press and hold the seat belt buckle switch for 10 seconds.

- The seat belt warning light will illuminate and a chime will sound.

4. Release the seat belt buckle switch.

- The seat belt warning light will turn off and the chime will stop.

5. Press the buckle to release your seat belt.

- It might show disabled on DIC for seatbelt.

The seat belt alarm will now be disabled until the next time you start the engine.

Auto Repair
How do you replace a fuel filter on 1997 Chrysler Concorde? 5 Car Security Tips to Protect Your Ride
Car Care
5 Car Technologies for a More Comfortable Winter Drive How to Clean Your Car With a Pressure Washer? (7 Steps) Wifes car idles very low and runs really crappy if i idle it up by pressing the gas its find. also fine while driving. 1997 Malibu?
Engine
Are Suzuki ls 650 engine the same as dr engine? Where is the PCV valve on a 1997 ford f150 4.2 engine?
Electric Car
Where is the air filter located on a 2002 Suzuki XL7? Why doesnt the heater on your 1999 Chevrolet suburban work? Where is heater control valve on 1998 Chevy Astro Van?
Autopilot
How do you set the trip odometer on a Harley Davidson Electra Glide Ultra Classic? Gta san Andreas on ps2 Nissan skyline cheat?
Car Photos
Where is the fuse location for side mirror on Mercedes ML350? How can you get your headlights to close on 1986 Nissan 300zx? Is the 2006 Nissan Xterra front wheel drive rear or four drive?