- New oil pan (check your owner's manual for the correct size)
- Oil pan gasket
- Oil filter
- Oil filter wrench
- Ratchet
- Socket wrench
- Extension
- Funnel
- 5 quarts of oil (check your owner's manual for the correct type)
- Safety glasses
- Gloves
Instructions:
1. Park your car on a level surface and turn off the engine.
Allow the engine to cool down completely before proceeding.
2. Engage the parking brake.
3. Put your car up on ramps or jack stands.
Make sure the car is securely supported before crawling underneath it.
4. Locate the oil pan.
It is usually located under the engine, near the front of the car.
5. Remove the oil drain plug.
Allow the oil to drain completely into a drain pan.
6. Clean the oil pan and the mating surface on the engine block.
Remove any old gasket material or sealant.
7. Apply a thin bead of sealant to the new oil pan gasket.
8. Install the new oil pan gasket on the oil pan.
9. Carefully install the oil pan.
Make sure that the gasket is seated properly and that the bolts are tightened securely.
10. Replace the oil drain plug and tighten it securely.
11. Lower your car off of the ramps or jack stands.
12. Add 5 quarts of new oil to the engine.
Use the funnel to add the oil slowly, and check the oil level frequently.
13. Start the engine and let it run for a few minutes.
Check for any leaks.
14. Turn off the engine and check the oil level again.
Add more oil if necessary.
