Tools and Materials Needed:
* Jack and jack stands
* Wheel lug wrench
* Socket set
*Pry bar
*New rear wheel bearings
* Sealant
* Grease
Instructions:
1. Park your car on a level surface.
2. Chock the front wheels to prevent the car from rolling.
3. Jack up the car and place jack stands under the frame to support it.
4. Remove the lug nuts and take off the wheel.
5. Remove the brake caliper by unbolting it from the hub assembly.
6. Remove the brake rotor.
7. Pry the bearing cap off the hub assembly using the pry bar.
8. Carefully remove the old bearing from the hub assembly.
9. Clean the hub assembly and bearing housing thoroughly.
10. Apply sealant to the outer surface of the new bearing.
11. Carefully insert the new bearing into the housing and press it in until it is fully seated.
12. Reinstall the bearing cap and tighten it down securely.
13. Reinstall the brake rotor.
14. Reinstall the brake caliper.
15. Put the wheel back on and tighten the lug nuts.
16. Lower the car and remove the jack stands.
Additional Notes:
* Be careful not to damage the brake caliper or rotor when removing them.
* Take care not to lose any of the small parts, such as the dust cap, when removing the old bearings.
* Make sure to grease the new bearings before installing them.
* Tighten the lug nuts to the manufacturer's recommended torque specification.
