- Replacement v-belt
- 17mm wrench
- 13mm wrench
- Flat-head screwdriver
- Pliers
Instructions:
1. Park your car in a safe location and turn off the engine.
2. Open the hood of your car.
3. Locate the v-belt tensioner pulley. It is located on the front of the engine, near the top.
4. Loosen the v-belt tensioner pulley bolt. Use the 17mm wrench to do this.
5. Pry the v-belt off of the tensioner pulley. Use the flat-head screwdriver to do this.
6. Remove the v-belt from the other pulleys. Use the 13mm wrench to do this.
7. Install the new v-belt. Start by wrapping it around the crankshaft pulley. Then, wrap it around the water pump pulley and the alternator pulley. Finally, wrap it around the tensioner pulley.
8. Tighten the v-belt tensioner pulley bolt. Use the 17mm wrench to do this.
9. Close the hood of your car.
Tips:
* Make sure that the new v-belt is the correct size for your car.
* If you are having trouble removing the v-belt, you can use a pair of pliers to help you.
* Be careful not to drop the v-belt into the engine.
