Here's a general procedure. Specific details might vary slightly depending on your exact trim level and options, so always refer to a repair manual specific to your 2007 Dodge Charger SE for the most accurate instructions. A factory service manual is ideal.
Tools you'll likely need:
* Socket wrench set (metric)
* Screwdrivers (Phillips and possibly flathead)
* Possibly a ratchet and extensions
* Wire cutters/crimpers (if disconnecting electrical connectors)
* Possibly a helper
Steps:
1. Disconnect the Battery: This is crucial for safety. Disconnect the negative (-) terminal first.
2. Remove Seat Belts: Unbuckle the seatbelts and remove them from their retractors. There might be a retaining bolt or clip that needs to be removed to release the retractor assembly.
3. Locate and Disconnect Electrical Connectors: There will be electrical connectors for the seat heaters (if equipped), seat position sensors, and possibly airbag sensors. Carefully disconnect these connectors. Some have locking tabs; others may simply pull apart. Take photos or make notes to remember how they connect for reassembly.
4. Remove the Seat Bolts: Most likely, you'll find several bolts securing the seat to the floor. These are usually located under the seat itself, and possibly along the seat rails. You'll need to feel around underneath and possibly use a flashlight to locate them all. A repair manual will show the exact locations and sizes.
5. Lift the Seat: Once all the bolts are removed, carefully lift the seat out of the vehicle. Because of its weight and size, having a helper is recommended.
6. Disconnect any remaining parts: If there are any additional brackets, linkages, or cables attached to the seat that you haven't yet disconnected, carefully remove those as well.
Reinstallation:
Reinstallation is essentially the reverse of the removal process. Ensure all connectors are properly reconnected and all bolts are tightened securely. Reconnect the battery after the seat is fully installed.
Important Considerations:
* Airbag System: If your car is equipped with side impact airbags in the seats, be extremely careful during removal and reinstallation. Improper handling could trigger the airbags or damage the system. If you're uncomfortable working around the airbag system, it's best to have a qualified mechanic do this.
* Repair Manual: Again, strongly recommended. A factory service manual will have detailed diagrams and instructions specific to your vehicle. This will make the process much safer and easier. You can often find these manuals online or from automotive parts stores.
This is a general guide. Always consult a repair manual for your specific vehicle before attempting this. Incorrect removal or reinstallation could damage your vehicle or lead to safety hazards. If you're not comfortable with this procedure, take your car to a qualified mechanic.
