1. Gather the necessary tools and materials:
1. New 6X9 speakers
2. Phillips head screwdriver
3. Pry tool
4. Wire cutters/strippers
5. Electrical tape
6. Soldering iron (optional)
2. Remove the rear seat:
1. Fold down the rear seat.
2. Locate the two bolts holding the rear seat in place and remove them.
3. Lift the rear seat up and remove it from the vehicle.
3. Remove the rear speaker covers:
1. Locate the two screws holding the rear speaker covers in place and remove them.
2. Remove the speaker covers.
4. Disconnect the speaker wires:
1. Use the pry tool to carefully pry the speaker wire connectors off the speaker terminals.
2. Be careful not to damage the speaker terminals.
5. Remove the old speakers:
1. Use the Phillips head screwdriver to remove the four screws holding the old speakers in place.
2. Remove the old speakers from the vehicle.
6. Install the new speakers:
1. Place the new speakers in the speaker holes.
2. Secure the new speakers with the four screws removed earlier.
3. Reconnect the speaker wires:
1. Reconnect the speaker wire connectors to the speaker terminals.
2. Make sure the positive (+) and negative (-) wires are correctly connected.
7. Test the new speakers:
1. Turn on the radio and check if the new speakers are producing sound.
8. Reinstall the rear speaker covers:
1. Reinstall the rear speaker covers and secure them with the screws.
9. Reinstall the rear seat:
1. Place the rear seat back into the vehicle and make sure it is properly seated.
2. Secure the rear seat with the two bolts removed earlier.
That's it! You have successfully replaced the rear 6X9 speakers in your 2000 Dodge Intrepid ES.
