---
1. Disconnect the battery. This will prevent any electrical accidents from happening while you are working on the seats.
2. Remove the seat belts. There are two bolts on each seat belt that need to be removed.
3. Remove the rear seat cushion and backrest.
* There are a total of 4 bolts holding the rear seat cushion and backrest to the floor. Use a 15mm socket to loosen the bolts. The seat cushion can then be lifted out of the car, followed by the backrest.
4. Disconnect the seat harness plug - There is a plastic cover on either side of the seat, underneath the seat. Gently pry up the edge of the cover and pull it off. Disconnect the harness clip from the harness in the floorboard.
5. Remove the seat mounting bolts. There are four bolts that hold each seat to the floor. Use a 15mm socket to loosen the bolts.
6. Lift the seats out of the car. Be careful not to drop the seats on your feet.
Re-install the seats in reverse order.
----
Note: If the seats are power seats, you may need to disconnect the power connector before you can remove the seats.
