The stop light switch is typically located on the brake pedal. When you press the brake pedal, the stop light switch is activated, which sends a signal to the brake lights to turn on.
On a Toyota Sequoia, the stop light switch is located at the top of the brake pedal, just below the dashboard. It is a black plastic switch with a single wire connector. To remove the stop light switch, you will need to disconnect the wire connector and then unbolt the switch from the brake pedal.
Here are the step-by-step instructions on how to replace the stop light switch on a Toyota Sequoia:
1. Disconnect the negative battery terminal. This will prevent the brake lights from turning on while you are working on the switch.
2. Locate the stop light switch. It is located at the top of the brake pedal, just below the dashboard.
3. Disconnect the wire connector from the stop light switch.
4. Unbolt the stop light switch from the brake pedal.
5. Remove the old stop light switch from the vehicle.
6. Install the new stop light switch in the reverse order that you removed the old switch.
7. Reconnect the negative battery terminal.
8. Test the brake lights to make sure that they are working properly.
_If you are not comfortable performing this repair yourself, you can take your Toyota Sequoia to a qualified mechanic to have it done._
