Turn off the ignition.
Disconnect the negative terminal.
-Use a 10mm wrench to loosen the nut on the negative terminal and remove the cable from the battery.
- Be careful not to touch the positive terminal with the negative cable, as this could cause a short circuit.
Disconnect the positive terminal.
-Use a 10mm wrench to loosen the nut on the positive terminal and remove the cable from the battery.
Remove the battery.
-Lift the battery out of the battery compartment.
Install the new battery.
-Place the new battery in the battery compartment.
-Connect the positive terminal to the battery.
-Connect the negative terminal to the battery.
Tighten the nuts on the battery terminals.
-Use a 10mm wrench to tighten the nuts on the positive and negative terminals until they are snug.
Turn on the ignition.
