Step-by-Step Guide:
1. Tools Needed:
- Flashlight
- T20 Torx Screwdriver
- Phillips Head Screwdriver
- Replacement Headlights
2. Disconnect Negative Battery Terminal:
- Open the hood of your Galant.
- Locate the negative (-) battery terminal.
- Loosen the nut on the terminal using the appropriate wrench or socket.
- Remove the nut and disconnect the battery terminal.
3. Remove Headlight Bezel:
- On the front side of the vehicle, locate the headlight bezel.
- Use the T20 Torx screwdriver to remove the screws securing the bezel.
- Gently pull the bezel forward to release it from the clips.
4. Remove Headlight Bulb Retainer:
- Behind the headlight bezel, locate the headlight bulb retainer.
- Turn the retainer counterclockwise to unlock it.
- Carefully remove the retainer from the housing.
5. Replace the Headlight Bulb:
- Remove the old headlight bulb by gently twisting it counterclockwise.
- Install the new headlight bulb by aligning the pins and twisting it clockwise until it's secure.
6. Reattach Headlight Bulb Retainer:
- Reattach the headlight bulb retainer by turning it clockwise to lock it in place.
7. Reinstall Headlight Bezel:
- Position the headlight bezel back into its original position.
- Use the T20 Torx screwdriver to insert and tighten the screws that secure the bezel.
8. Reconnect Battery:
- Reconnect the negative (-) battery terminal by placing the terminal back onto the negative post and tightening the nut.
9. Test the Headlights:
- Turn on your Galant's lights and visually inspect that the new headlights are working properly.
10. Verify Aim and Intensity:
- Depending on your location and driving laws, you may need to verify the aim and intensity of your new headlights. Follow the guidelines provided by your local regulations.
Remember to follow any safety precautions and refer to your vehicle's owner's manual for specific details that apply to your 2000 Mitsubishi Galant. This guide provides general steps, but the actual process may vary based on your vehicle's exact model and trim level.
