[Image of the serpentine belt diagram for a 1996 Oldsmobile 98]
Here is a step-by-step guide on how to replace the serpentine belt on a 1996 Oldsmobile 98:
Tools Needed:
- Wrench set
- Socket set
- Jack and jack stands
Instructions:
1.) Park the vehicle on a level surface and apply the parking brake.
2.) Turn off the engine and allow it to cool.
3.) Raise the front of the vehicle with a jack and support it on jack stands.
4.) Locate the serpentine belt tensioner. It is usually located on the front of the engine, near the top.
5.) Loosen the tensioner bolt using a wrench or socket.
6.) Remove the old serpentine belt from around the pulleys.
7.) Place the new serpentine belt around the pulleys, starting with the crankshaft pulley.
8.) Tighten the tensioner bolt until the belt is snug.
9.) Lower the vehicle from the jack stands.
10.) Start the engine and check the belt for proper tension.
Note: Always refer to the vehicle owner's manual for specific instructions and torque specifications.
