Here's a step-by-step guide on how to access and replace the cabin air filter:
1. Open the Glove Box: Open the glove box on the passenger side of your Explorer Sport Trac.
2. Locate the Release Button: Look for a release button or latch on the left-hand side of the glove box. Press or slide the button to release the glove box.
3. Remove the Glove Box: Once the release button is pressed, gently pull the glove box towards you to disconnect it from its hinges and remove it from the vehicle.
4. Locate the Filter Housing: Behind the glove box, you'll see the housing that contains the cabin air filter. It's typically a rectangular or square box made of plastic.
5. Remove the Filter Housing Cover: There may be a latch or small tabs on the filter housing cover. Press the tabs or slide the latch to release the housing cover.
6. Take Out the Old Filter: Once the cover is removed, you'll see the old cabin air filter inside the housing. Carefully pull it out and discard it.
7. Install the New Filter: Take the new cabin air filter and insert it into the housing. Make sure the new filter is properly seated and aligns with the frame of the housing.
8. Reinstall the Filter Housing Cover: Place the filter housing cover back into its original position and secure it by pressing the tabs or sliding the latch.
9. Replace the Glove Box: Reinsert the glove box by aligning it with the hinges and gently pushing it back into place until it clicks or latches.
10. Close the Glove Box: Close the glove box securely.
Note: The cabin air filter should be replaced regularly, usually once a year or every 12,000 miles, to maintain optimal airflow and filtration in your Explorer Sport Trac. Always refer to your vehicle's owner's manual for specific recommendations and instructions.
