Auto >> AutoSPT >  >> Electric car

To change the drivers side power window motor on a 1993 Mercury Capri are there compatible parts you can use or do have to that specific motor?

1993 Mercury Capri Driver-side Power Window Motor Replacement

Compatible parts:

- 1993 Mercury Capri driver-side power window motor

- 1992 Mercury Capri driver-side power window motor

- 1991 Mercury Capri driver-side power window motor

Tools:

- Socket set

- Phillips head screwdriver

- Flat head screwdriver

- Wire cutters

- Electrical tape

Instructions:

1. Disconnect the negative battery terminal using the pliers.

2. Remove the door panel.

3. Remove the Phillips head screws that secure the power window motor to the door.

4. Disconnect the electrical connector from the power window motor.

5. Remove the power window motor from the door.

6. Install the new power window motor in the reverse order of removal.

7. Reconnect the negative battery terminal.

8. Test the power window motor to make sure it is working properly.

Auto Repair
How do you reset the fuel pump or security breaker on a 1999 Lincoln Navigator? How do you change the front brake pads on a 2000 GM Sonoma?
Car Care
How to Track My Car Location How to ‘Read’ Your Spark Plugs To Learn Your Engine’s Secrets What is the best 300cc dune buggy to purchase?
Engine
Which oxygen sensor is most commonly replaced on a 2000 ford expedition 46 engine? What are the two energys when your produced by a haor dryer?
Electric Car
Is it harmful to your car run near empty on gas? What does trouble code p1229 mean in a Toyota corolla 2006? Where is spare tire located on 2000 Chevy Venture?
Autopilot
Sharpening the eyes of self-driving cars Day 10 Capability: Increase speed for needed lane changes
Car Photos
Where is 2004 Chevy Malibu tail light fuse? What is the towing capacity of 2007 Toyota Camry? Is the 2014 Audi A6 front wheel drive rear or four drive?