Auto >> AutoSPT >  >> Electric car

Where is the blower motor resistor located on a 1998 ford explorer?

1. Locate the blower motor resistor. On a 1998 Ford Explorer, the blower motor resistor is located inside the passenger compartment, on the passenger side, behind the glove box.

2. Remove the glove box. To remove the glove box, open it and squeeze the release tabs located on the sides. Then, pull the glove box towards you to unlatch it.

3. Locate the blower motor resistor. Once the glove box is removed, you will see the blower motor resistor mounted on the HVAC housing. It is a small, black, rectangular box with two electrical connectors attached to it.

4. Disconnect the electrical connectors. To disconnect the electrical connectors, press the release tabs on the connectors and pull them straight up.

5. Remove the blower motor resistor. Once the electrical connectors are disconnected, you can remove the blower motor resistor by unscrewing the mounting screws and pulling it out of the housing.

Auto Repair
What does a auto mechanic have to wear work? Why the windshield wiper stopped working in your Nissan 240sx?
Car Care
Idle Air Control Valve Symptoms – Keep An Eye Out For The Check Engine Light!  How Much Does a Fully Loaded 2022 Genesis GV70 Cost? Too Hot? Too Loud? Too Slow?
Engine
What is the lower intake manifold torque spec on a 97 Chevy 5.7L? What is the towing capacity of a 2001 Ford F 350 with 7.3 diesel?
Electric Car
Why does your 2001 ford f350 run rough and skip? What is the angle of departure 2005 Chevrolet Suburban? Where is the blower motor resistor on a 2000 ford F-350?
Autopilot
What does a motorbike do? Where can you find a rear rim for an APC Mini Harley?
Car Photos
Do you have a picture of the firing order Nissan truck 1989 model D21? What are some classic Ford truck part sources? Where is the speed sensor located on a 1999 Honda Passport?