Auto >> AutoSPT >  >> Electric car

How do you bleed gas line on 87 Nissan pickup?

To bleed the gas line on an 87 Nissan Pickup, follow these steps:

  1. Make sure the fuel tank is full.

  2. Locate the fuel filter. On the 1987 Nissan Pickup, it is located under the driver's side floorboard.

  3. Loosen the fuel line connector at the fuel filter. Be careful not to spill any fuel.

  4. Have an assistant crank the engine while you watch the fuel line connector. When fuel begins to flow out, tighten the connector.

  5. Repeat steps 3 and 4 until no more air bubbles are visible in the fuel line.

  6. Start the engine and let it run for a few minutes to make sure the fuel system is working properly.

Note: If you are having trouble bleeding the fuel line, you may need to replace the fuel filter.

Auto Repair
How long does it take to fix a broken speed odometer on Chevy trailblazer? How to repair a Transmission Mount?
Car Care
What Are The Differences Between Car Seatbelt Design And Airplane Seatbelt? Here’s How to Replace Windshield Wipers and Fluid What is the law on car remorse in Virginia?
Engine
Evinrude 25 horsepower outboard prop slips while under a load. Or could it be cavitation? Check engine light flashing on a 03 ford expedition?
Electric Car
Is electrical energy is converted in to solar energy? Different reasons why the low oil yellow indicator light goes on occasionally at start up of car and remains - 1995 Chevy lumina? What size rental truck do you need for 40 cubic yards?
Autopilot
Can you drive a 50cc scooter on the interstate in Florida? How do you read srs blink on Honda Accord 2005?
Car Photos
Where are the front and rear lift points on frame for use with a floor jack 2004 Buick LeSabre? Where is the fuse box for stereo in a 2003 Mazda 6? 99 Toyota Camry timing belt set up need pic setup diagram?