Identify the Distributor Terminals:
1. Locate the distributor cap on the side of the engine block, usually near the front.
2. Remove the distributor cap by pressing down on the retaining clips and lifting it off.
3. Inside the distributor, you'll see four terminals labeled "1," "2," "3," and "4."
Identify Ignition Coil Terminals:
1. Locate the ignition coil, which is typically mounted on the side of the engine block or the firewall.
2. Identify the three terminals on the ignition coil: "+" (positive), "-" (negative), and "C" (coil terminal).
Connect the Distributor and Coil:
1. Connect the wire from terminal "1" on the distributor to the "+" terminal on the ignition coil.
2. Connect the wire from terminal "4" on the distributor to the "-" terminal on the ignition coil.
3. Connect the wire from terminal "C" on the coil to terminal "3" on the distributor.
Additional Points to Consider:
1. Check your vehicle's specific wiring diagram for exact connections, as there can be variations based on the year and model of your vehicle.
2. Verify the proper positioning of the distributor rotor before reattaching the distributor cap.
3. Reconnect the distributor cap securely to ensure a good connection and prevent ignition issues.
By following these steps, you should successfully connect a 22r distributor and coil. However, if you encounter any problems or are unsure about the wiring process, it's recommended to seek the assistance of a professional mechanic.
