Necessary tools and materials Needed :
- Phillips Head Screwdriver
- Flat Head Screwdriver
- Replacement Corner Light Bulbs
Note: Before you start, make sure your car is turned off and allowed to cool down if the engine has been running. Engage the parking brake.
Steps:
1. Open the Hood: Pull the hood release lever inside your car and then lift the hood. Secure it with the hood prop.
2. Locate the Corner Light Assembly: The corner lights in a 92 Acura Integra are located on the upper outer corner of each front headlight assembly.
3. Remove the Screws: There will be two screws securing the corner light assembly in place. Use a Phillips head screwdriver to remove these screws.
4. Disconnect the Wiring Connector: Once the screws are removed, disconnect the wiring connector attached to the corner light assembly. Be gentle and avoid pulling on the wires.
5. Remove the Corner Light Assembly: After the wiring connector is disconnected, you can carefully pull out the corner light assembly.
6. Replace the Bulb: Remove the old bulb from the corner light assembly. Be cautious when handling the glass bulb. Install a replacement bulb of the same type and size.
7. Reinstall the Corner Light Assembly: Place the corner light assembly back in its place and secure it using the screws you removed earlier.
8. Reconnect Wiring Connector: Connect the wiring connector that you disconnected earlier. Ensure that it's secure.
9. Test the Corner Lights: Turn on your headlights and check if the corner lights are functioning properly.
10. Repeat for the Other Side: If you need to replace the corner light on the other side of the vehicle, follow the same steps.
Tips:
- When replacing the bulbs, consider using high-quality replacements that provide adequate brightness and clarity.
- Be cautious when handling the glass bulbs to avoid any breakage.
- This process can also be applied to replace the turn signal bulbs on the 92 Acura Integra.
