1. 10 mm socket
2. 12 mm socket
3. 14 mm socket
4. Spark plug socket
5. 3-inch extension
6. Ratchet
Instructions:
1. Remove the ignition coils by unbolting the three 10mm bolts. There is one above each spark plug.
2. Remove the rubber boot by pulling straight up on the boot.
3. Use a 3-inch extension on your ratchet and insert it into the spark plug socket, then connect it to the ratchet. Place the spark plug socket over the spark plug with the spark plug socket touching the plug's base.
4. Turn the ratchet counterclockwise to loosen the spark plug. Make sure to support the spark plug from the outside with a socket or wrench so it doesn't drop into the engine.
5. Disconnect the extension and remove the old spark plug.
6. Install the new spark plug by applying a small amount of anti-seize grease to the threads and finger-tighten it.
7. Connect the spark plug socket (with extension if necessary) to the ratchet and turn it clockwise until hand-tight.
8. Reinstall the ignition coil boots and bolts, then connect the spark plug wire clips to the ignition coils.
