2. Remove the glove compartment.
There are two screws on the sides of the glove compartment.
Remove the two screws and remove the glove compartment.
3. Locate the blower motor resistor.
The blower motor resistor is located behind the glove compartment.
It is a black plastic box with a few wires connected to it.
4. Disconnect the wires from the blower motor resistor.
There are three wires connected to the blower motor resistor.
Disconnect the wires by pressing down on the plastic tab and pulling the wires out.
5. Remove the blower motor resistor.
Remove the two screws that hold the blower motor resistor in place.
Remove the blower motor resistor from the vehicle.
6. Install the new blower motor resistor.
Install the new blower motor resistor in the reverse order of removal.
7. Connect the battery.
Reconnect the battery negative terminal.
