Tools:
- Phillips head screwdriver
- Flat head screwdriver
- 12 mm wrench
- Hammer
Instructions:
1. Turn the ignition switch to the "Off" position.
2. Insert the flat head screwdriver into the small hole located on the left side of the ignition switch.
3. Gently pry the cover off of the ignition switch.
4. Use the Phillips head screwdriver to remove the two screws that hold the ignition switch in place.
5. Locate the electrical connector at the back of the ignition switch.
6. Press down on the release tab and disconnect the electrical connector.
7. Use the 12 mm wrench to loosen the nut that holds the ignition switch in place.
8. Remove the nut and pull the ignition switch out of the steering column.
