1. Open the hood of your vehicle.
2. Locate the large plastic engine cover at the top of the engine. There is a "V6 3.5" marking in the center of the cover.
3. Remove the plastic cover by loosening the bolt located on its right side and then detaching the two metal clips.
4. Once the cover is removed, you'll see the oil filter housing on the left side of the engine block.
5. The oil filter is located inside the housing. To access it, you'll need to use an oil filter wrench to loosen the oil filter cap.
6. Once the cap is loosened, remove it by hand and take out the old oil filter.
7. Install a new oil filter and replace the oil filter cap.
8. Tighten the bolt on the engine cover and reattach the metal clips.
Here is a visual representation of the oil filter location:
[Image of 2007 Chrysler 300 engine with oil filter location marked]
Note: Make sure to consult the owner's manual for the exact location of the oil filter on your specific model and year. The location may vary depending on the engine type and configuration.
