Auto >> AutoSPT >  >> Electric car

How do you replace high mount brake light for 02 Toyota Camry?

Replacing the high mount brake light on a 2002 Toyota Camry is a simple task that can be completed in a few minutes. Here are the steps involved:

1. Gather the necessary tools and parts. You will need a Phillips head screwdriver, a flat head screwdriver, and a replacement brake light.

2. Open the trunk of your Camry.

3. Locate the brake light assembly. It is located at the top of the rear window, just below the spoiler.

4. Remove the two Phillips head screws that hold the brake light assembly in place.

5. Use the flat head screwdriver to pry the brake light assembly out of its housing. Be careful not to damage the paint on your car.

6. Disconnect the electrical connector from the brake light assembly.

7. Remove the old brake light bulb by turning it counterclockwise.

8. Install the new brake light bulb by turning it clockwise until it is snug.

9. Reconnect the electrical connector to the brake light assembly.

10. Snap the brake light assembly back into its housing.

11. Replace the two Phillips head screws that hold the brake light assembly in place.

12. Test the brake light to make sure it is working properly.