Auto >> AutoSPT >  >> Electric car

How do you change rear spark plugs in a 2001 Toyota Sienna?

To change the rear spark plugs in a 2001 Toyota Sienna, you will need the following tools:

* A spark plug wrench

* A ratchet and extension

* A 5/8-inch socket

* A spark plug gap gauge

Here are the steps on how to change the rear spark plugs in a 2001 Toyota Sienna:

1. Remove the engine cover.

2. Locate the spark plugs. The rear spark plugs are located on the back of the engine, near the firewall.

3. Disconnect the spark plug wires from the spark plugs.

4. Unscrew the spark plugs with the spark plug wrench and remove them from the engine.

5. Check the gap of the new spark plugs with the spark plug gap gauge. The gap should be set to 0.044 inches.

6. Screw the new spark plugs into the engine and tighten them with the spark plug wrench.

7. Connect the spark plug wires to the new spark plugs.

8. Replace the engine cover.

Changing the spark plugs in a 2001 Toyota Sienna is a relatively easy job that can be completed in about 30 minutes.

Auto Repair
If your truck was repossessed in PA what steps are usually required to get it back? What are recommended tire pressures for 2002 buick regal?
Car Care
How To Pick The Right Tires For Your Vehicle What kind od insurance would you need for your non medical transportation company? The Evolution of Power Steering Systems
Engine
Who makes a GM 5.7 L6 engine? Where isAir ride compressor 93 mark viii?
Electric Car
Where is the air flow sensor on a 2001 Saturn s-1? Where is the oil pressure sending unit located on a 2003 cadillac escalade? Pod Point units rolled out at Fuller’s pubs
Autopilot
How to advance timing on a 50cc gy6 scooter motor? Day 14 Capability: Perform high speed merge
Car Photos
What brand of car have full leather seats? Can a buyer sign title and buy the car then decide they want car? Where can i find a fuse diagram located under the hood of 2002 mustang?