Auto >> AutoSPT >  >> Engine

What oil do you use on a Briggs Straton 12hp ride mower?

SAE 30 oil is recommended for use in a Briggs & Stratton 12 HP ride mower. This type of oil is a single-grade, non-detergent oil that is specifically designed for use in small engines. It is important to use the correct type of oil in your ride mower, as the wrong type of oil can damage the engine.

Here are some additional tips for changing the oil in your Briggs & Stratton 12 HP ride mower:

1. Make sure that the engine is cool before you begin.

2. Drain the old oil from the engine.

3. Replace the oil filter (if applicable).

4. Fill the engine with new SAE 30 oil.

5. Check the oil level and add more oil if necessary.

Changing the oil in your ride mower is a simple task that can help to extend the life of your engine. By following these tips, you can ensure that you are using the correct type of oil and that the oil is changed at the correct intervals.

Auto Repair
How do you remove and replace front wheel bearings on a 1996 Chevy Blazer 4x4? How do you replace the fuel filter located on a 1993 Jeep Cherokee?
Car Care
How to Tell If Coil Pack is Bad: Signs, Problems, and Solutions! Is it ok to put vans in the washer? Top tips for CNG car maintenance
Engine
Where would coolant be leaking from when pouring out of bottom engine your 1991 v8 camaro? What is the fuel oil ratio on a 1996 Honda cr 125?
Electric Car
Where is the anti theft relay located in a 2001 Nissan Sentra? Tesla Mileage and Range – We’ve Covered It All Why is 1997 Buick Park avenue heater blows hot air on side while blowing cold passenger side?
Autopilot
Industries’ Response to Driverless Cars How do you set the clock on a 2001 Honda Civic EX?
Car Photos
Most luxuries car in the world? Hyundai Venue 2019 1.4 CRDi MT E Interior How many 1970 torino gt convertibles made?