1. Disconnect the battery from the generator.
2. Remove the voltage regulator from the generator.
3. Connect a voltmeter to the generator's output terminals.
4. Connect a 12-volt power supply to the generator's input terminals.
5. Start the power supply.
6. The voltmeter should read approximately 14.5 volts.
7. If the voltmeter does not read 14.5 volts, the generator is faulty and should be replaced.
Here are some additional tips for bench testing a Harley Davidson generator:
- Make sure the generator is properly grounded before starting the power supply.
- Do not exceed the generator's maximum output voltage.
- If the voltmeter reads more than 14.5 volts, the voltage regulator is faulty and should be replaced.
- If the voltmeter reads less than 14.5 volts, the generator is faulty and should be replaced.
