Can you put a power band on ttr 125cc?

Yes, you can put a power band on a TTR 125cc. A power band is a modification to the engine that helps increase its power output. It is typically done by adding a band of material around the piston that helps improve the seal and increase compression. This can result in a significant increase in power and performance, especially at higher RPMs.

Installing a power band is not a difficult process, but it does require some mechanical skill. It is also important to note that installing a power band may void the warranty on your bike. If you are not comfortable doing the installation yourself, you can always take it to a qualified mechanic.

Here is a general guide on how to install a power band on a TTR 125cc:

1. Remove the cylinder head. This can be done by removing the four bolts that hold it in place.

2. Remove the piston. This can be done by using a piston ring compressor to compress the rings and then tapping the piston out of the cylinder with a rubber mallet.

3. Install the power band. Simply slip the power band over the piston and then re-install the piston into the cylinder.

4. Re-install the cylinder head. Make sure to tighten the bolts in a star pattern to avoid warping the head.

5. Start the bike and test it out. You should notice an immediate improvement in power and performance.

It is important to note that installing a power band may also increase the strain on your engine. Therefore, it is important to inspect your engine regularly and make sure that it is in good condition. If you have any concerns about installing a power band, it is best to consult with a qualified mechanic.