Tools and Materials You'll Need:
* New oil: Refer to your owner's manual for the correct type and quantity of oil (typically around 0.8-1.0 liters). Use a high-quality 10W-30 or 10W-40 motorcycle oil.
* New oil filter: Again, check your owner's manual for the correct part number.
* Oil filter wrench: The size will depend on your specific model.
* Wrench for the drain plug: This is usually a 14mm or 17mm wrench, but check your manual.
* Drain pan: To catch the old oil.
* Funnel: To make pouring the new oil easier.
* Jack or stands: To safely lift the scooter and provide access to the drain plug. A center stand is ideal if your scooter has one.
* Gloves: To protect your hands from dirty oil.
* Rags or paper towels: For cleaning up spills.
Steps:
1. Warm up the engine: Run the engine for 5-10 minutes to warm the oil, making it flow more easily.
2. Secure the scooter: Use a jack or center stand to lift the scooter securely. Ensure it's stable and won't tip over.
3. Locate the drain plug: This is usually located on the bottom of the engine crankcase.
4. Position the drain pan: Place the drain pan under the drain plug.
5. Remove the drain plug: Carefully loosen and remove the drain plug using the appropriate wrench. Be cautious as the oil will be hot. Let the oil drain completely. This may take 15-20 minutes.
6. Locate the oil filter: This is usually accessible near the engine.
7. Remove the oil filter: Use the oil filter wrench to carefully remove the old oil filter. Have a rag ready to catch any remaining oil.
8. Install the new oil filter: Lightly lubricate the rubber gasket on the new oil filter with fresh oil. Screw the new filter on by hand until it's snug. Do not overtighten.
9. Replace the drain plug: Once the oil has completely drained, replace the drain plug and tighten it to the manufacturer's specified torque (check your owner's manual). Do not overtighten.
10. Add new oil: Using a funnel, pour the correct amount of new oil into the engine. Check your owner's manual for the exact quantity.
11. Check the oil level: Use the dipstick to check the oil level. Add more oil if necessary until it reaches the "full" mark.
12. Lower the scooter: Carefully lower the scooter from the jack or stands.
13. Start the engine: Run the engine for a few minutes.
14. Check for leaks: Inspect the area around the drain plug and oil filter for any leaks.
15. Check the oil level again: After running the engine, let it sit for a few minutes, then check the oil level again and top off if needed.
16. Dispose of used oil properly: Take the used oil to a recycling center or auto parts store that accepts used oil.
Important Notes:
* Consult your owner's manual: This guide is for general information only. Always refer to your Yamaha Breeze 125 owner's manual for specific instructions, torque specifications, and recommended oil type and quantity.
* Safety first: Wear gloves and work in a well-ventilated area. Hot oil can cause burns.
* Torque specifications: Over-tightening the drain plug or oil filter can damage the engine. Use a torque wrench if possible to ensure proper tightening.
If you are not comfortable performing this task yourself, it's best to take your scooter to a qualified mechanic. Improper oil changes can lead to engine damage.
