2. Remove the instrument panel.
3. Remove the center console.
4. Remove the glove box.
5. Remove the blend door actuator motor.
Here are the detailed steps:
1. Disconnect the negative battery cable. This will help to prevent any electrical shocks while you are working.
2. Remove the instrument panel. There are four screws that hold the instrument panel in place, two on each side. Remove these screws and then carefully pull the instrument panel out of the dash.
3. Remove the center console. There are four screws that hold the center console in place, two on each side. Remove these screws and then lift the center console up and out of the truck.
4. Remove the glove box. There are two screws that hold the glove box in place, one on each side. Remove these screws and then pull the glove box down and out of the truck.
5. Remove the blend door actuator motor. The blend door actuator motor is located behind the glove box. It is held in place by three screws. Remove these screws and then disconnect the electrical connector from the motor. Finally, pull the motor out of the truck.
