* A screwdriver
* A hammer
* A punch
* A new ignition lock cylinder
Here are the steps to change the ignition lock cylinder:
1. Insert the key into the ignition and turn it to the "On" position.
2. Use the screwdriver to remove the two screws that hold the ignition switch cover in place.
3. Remove the ignition switch cover.
4. Use the hammer and punch to drive out the roll pin that holds the ignition lock cylinder in place.
5. Remove the ignition lock cylinder.
6. Insert the new ignition lock cylinder into the housing.
7. Drive in the new roll pin.
8. Replace the ignition switch cover.
9. Insert the key into the ignition and turn it to the "On" position to test the new ignition lock cylinder.
