* A Phillips head screwdriver
* A flat head screwdriver
* A 7mm socket wrench
1. Disconnect the negative battery cable.
2. Remove the two screws that hold the steering wheel cover in place.
3. Pry off the steering wheel cover.
4. Remove the two screws that hold the turn signal switch in place.
5. Disconnect the electrical connector from the turn signal switch.
6. Use the 7mm socket wrench to remove the nut that holds the turn signal switch in place.
7. Pull the turn signal switch out of the steering column.
To install a new turn signal switch, simply reverse the steps above. Be sure to reconnect the negative battery cable when you are finished.
