The camshaft position sensor (CPS) on a 2003 Ford Ranger is located on the front of the engine, just below the intake manifold. It is a small, black sensor with two wires connected to it.
To remove the camshaft sensor, follow these steps:
1. Disconnect the negative terminal of the battery.
2. Locate the camshaft sensor on the front of the engine.
3. Disconnect the two wires from the sensor.
4. Remove the two bolts that hold the sensor in place.
5. Remove the camshaft sensor from the engine.
When installing the new camshaft sensor, be sure to:
* Align the sensor with the camshaft before tightening the bolts.
* Torque the bolts to 10 ft-lbs.
* Reconnect the two wires to the sensor.
* Connect the negative terminal of the battery.
