Auto >> AutoSPT >  >> Engine

What do you if the slave cylinder will not bleed and cant get any pedal out of clutch?

1. Ensure the master cylinder is full of brake fluid.

2. Check the brake lines and fittings between the master cylinder and the slave cylinder for any leaks or damage.

3. Make sure the slave cylinder is properly installed and tightened.

4. Try bleeding the slave cylinder again, using a different method or tool if necessary.

5. If none of the above steps work, you may need to replace the slave cylinder.

Auto Repair
How do you change front brake rotors on a 1997 GM 4 wheel drive pickup? How do you program the garage door opener in a 2005 Chevy Tahoe?
Car Care
When Do you Need The Help of Auto Mechanics Near Me? What is the Life expectancy of a Nissan Pathfinder under normal driving conditions? Why a car wander?
Engine
How many horsepower does the engine in 2006 BMW X3 have? Why would there be no coolant in your radiator but the overflow tank is full?
Electric Car
What side of thermostat goes toward motor on a 2004 Chrysler Sebring? How much did a 1957 fuel injected Chevy cost? How much does a car factory earn?
Autopilot
How do you set time on 2002 Honda CR-V? Becoming an Autonomous Vehicle Engineer – Part 2: Software Skills
Car Photos
Hyundai Elite i20-2018 Asta (O) Diesel Exterior Is the 2010 Mazda MAZDA6 front wheel drive rear or four drive? Where is the cam shaft position sensor located on a Chrysler 2.7?