Auto >> AutoSPT >  >> Engine

How do you connect a 1990 Volvo 240 cruise control unit to the vacuum hose?

To connect the vacuum hose to the cruise control unit on a 1990 Volvo 240, follow these steps:

1. Locate the cruise control unit. It is usually mounted on the firewall in the engine compartment.

2. Remove the rubber cap from the back of the cruise control unit.

3. Insert the vacuum hose into the open port on the back of the cruise control unit.

4. Push the hose until it is fully seated in the port.

5. Replace the rubber cap.

6. Start the engine and check the operation of the cruise control.

Auto Repair
How do you bypass neutral safety switch on 1997 Toyota t-100? Is there a electrical reset switch?
Car Care
Tire FAQs 7 Tips to Keep Your Car Cool This Summer 5 Steps to Prepare Your Vehicle for Spring
Engine
How much horsepower does a 5.7 L 350 engine have? What would cause the humming and grinding in my left front wheel on 2002 dodge Dakota 4x4?
Electric Car
How can i tell the difference between a Chevrolet 350Ci and 305Ci 1986 in my C10 pickup? In Georgia do you have to pay sales tax on a vehicles purchased in Tennessee? What causes the transmission gears not to change in a 1999 Ford Taurus Station Wagon?
Autopilot
Automation Without Connectivity – Why Take The Risk? Is it easy to ride a motorcycle?
Car Photos
Where does Ford make their vehicles? Jaguar XE 2020 SE Diesel Exterior What car has the best mpg?