Tools:
- Soldering iron
- Solder
- Wire strippers
- Crimpers
- Screwdriver
- Pliers
Parts:
- Electronic ignition kit (includes electronic ignition module, pick-up coil, and wiring harness)
- Spark plugs (optional, but recommended)
Steps:
1. Remove the old points and condenser.
2. Install the pick-up coil on the engine block in place of the old points,
3. Connect the wires from the pick-up coil to the electronic ignition module.
4. Install the electronic ignition module in a convenient location on the motorcycle frame,
5. Connect the wires from the electronic ignition module to the spark plugs, battery, and ignition switch.
6. Test the ignition by starting the motorcycle and checking for spark at the spark plugs.
7. Adjust the timing of the electronic ignition module if necessary.
Note: _The exact steps for converting points to electronic ignition may vary depending on the specific motorcycle model and the electronic ignition kit being used. Refer to the instructions included with the electronic ignition kit for more detailed information._
