1. Gather Necessary Tools:
- Replacement Speedometer Cable
- Socket Wrench Set
- Phillips Screwdriver
- Flat-Head Screwdriver
2. Locate Speedometer Cable:
- Park your motorcycle on a level surface and turn off the engine.
- The speedometer cable is located on the right side of the motorcycle near the front wheel.
3. Remove Instrument Cluster Cover:
- Locate the screws that hold the instrument cluster cover in place.
- Use a Phillips screwdriver to remove these screws and take off the cover.
4. Disconnect Speedometer Cable:
- Follow the speedometer cable from the instrument cluster to where it connects to the transmission.
- Squeeze the retaining clip on the cable connector and pull it out to disconnect the cable.
5. Remove the Old Cable:
- Continue tracing the speedometer cable towards the front wheel.
- Look for the point where the cable is secured with a bracket.
- Loosen the bolts holding the bracket and release the cable.
- Remove the old cable by carefully pulling it out.
6. Install the New Cable:
- Insert the new speedometer cable through the bracket and feed it towards the transmission.
- Secure the cable by tightening the bolts on the bracket.
- Connect the cable to the transmission by pushing the connector into place and securing it with the retaining clip.
7. Reattach Instrument Cluster Cover:
- Place the instrument cluster cover back on the motorcycle and secure it with the screws you removed earlier.
8. Test the Speedometer:
- Start the engine and check if the speedometer is working correctly.
- Test ride the motorcycle to ensure the speedometer provides accurate speed readings.
9. Clean Up:
- Clean up any tools and materials you used during the replacement process.
Remember to follow any additional instructions or safety guidelines provided in the Kawasaki Voyager service manual for your specific motorcycle model.
