Auto >> AutoSPT >  >> Engine

How do you change choke cable on yamaha timberwolf?

1. Locate the choke cable. It is usually located on the left side of the handlebars, near the throttle cable.

2. Loosen the pinch bolt. This bolt holds the choke cable in place. Use a 10mm wrench to loosen the bolt until it is loose enough to slide off of the cable.

3. Remove the old choke cable. Slide the old choke cable out of the pinch bolt and carburetor bracket.

4. Install the new choke cable. Slide the new choke cable into the carburetor bracket and pinch bolt. Make sure that the cable is routed correctly, so that it can move freely when you pull on the choke lever.

5. Tighten the pinch bolt. Use a 10mm wrench to tighten the pinch bolt until it is snug.

6. Test the choke cable. Pull on the choke lever to make sure that the choke cable is working properly. The choke should open and close smoothly.

Auto Repair
Replace tail light 2004 Mitsubishi endeavor? How do you remove rear axles from 1998 4 wheel drive Chevy silverado?
Car Care
A Brief Discussion on Power Steering Fluid Types Steering and Suspension Repair – What You Need To Know Can I Repair My Own Car After An Accident? Learn How Your Insurance May Be Affected! 
Engine
When adjusting the valves on a chevy 350 do you adjust intake and exhaust? What is the disadvantage of using fossil fuels to generate electricity?
Electric Car
What type of transmission fluid does a suburban use? How do you change the heater motor for 1998 Chevy Lumina LTZ 3800? Where is the thermostat on a 1931 A model ford?
Autopilot
How often should you change crank sensor? Fellowship Published!
Car Photos
What is the rear track of 2011 BMW 1-Series? Is the 2008 Chevrolet Colorado front wheel drive rear or four drive? What are some good girls names for a car?