Auto >> AutoSPT >  >> Engine

How does the drive belt route for a john deere lx186?

1. Remove the mower deck. This will give you access to the drive belt.

2. Locate the drive belt. It is a long, black belt that runs from the engine to the transmission.

3. Remove the old drive belt. To do this, you will need to loosen the tensioner pulley. The tensioner pulley is located on the side of the engine.

4. Install the new drive belt. Wrap the new drive belt around the pulleys in the same way as the old drive belt.

5. Tighten the tensioner pulley. This will hold the drive belt in place.

6. Reinstall the mower deck.

Here is a diagram of the drive belt route for a John Deere LX186:

[Image of drive belt route for a John Deere LX186]

Note: The drive belt route may vary slightly depending on the year and model of your John Deere LX186. If you are unsure of how to route the drive belt, consult your owner's manual.

Auto Repair
What is Diagnostic Testing and Repair and Why Is It Important for Automobiles? Why would you hear a popping noise after your cv boot was changed on 1997 Nissan Pathfinder?
Car Care
Bent Frame Repair Cost: Is It Even Worth Fixing a Damaged Frame? Understanding how to care for your car 4 Reasons to Get Your Brakes Serviced Regularly
Engine
What is the correct torque for wheels lug of a Mercedes Benz C230? Where is the heater fuse on a 1993 Concorde?
Electric Car
How do you replace the water pump on a 1985 Toyota Tercel 4WD wagon? Is there a fuel pump relay button on 2000 Chrysler Sebring Convertible? What kind of engine does the 1970 Chevrolet Chevelle have in it?
Autopilot
Is there a way to change an odometer? Day 5 Capability: React to Congested Intersections
Car Photos
Where is the speed sensor in a 1999 Ford Ranger? What does the sign with a triangle and ford written in middle mean on road? Where can you find a classic car to restore?