- 10mm wrench
- Oil filter wrench
- New oil filter (Honda part number 15410-KWB-901)
- New oil (SAE 10W-30)
- Oil drain pan
- Funnel
Instructions:
1. Run the engine for a few minutes to warm up the oil. This will help the oil drain more easily.
2. Turn off the engine and let it cool down for a few minutes.
3. Place the oil drain pan under the oil drain plug, which is located on the bottom of the engine.
4. Use the 10mm wrench to loosen the oil drain plug and allow the old oil to drain out.
5. Once the old oil has drained out, replace the oil drain plug and tighten it securely.
6. Remove the old oil filter using the oil filter wrench. Be careful not to spill any oil.
7. Apply a thin coat of new oil to the gasket of the new oil filter.
8. Screw on the new oil filter by hand until it is snug. Do not overtighten the oil filter.
9. Add the new oil to the engine using the funnel. The oil capacity of the Honda Spree is 0.8 liters (0.85 US quarts).
10. Check the oil level using the oil dipstick. The oil level should be between the "FULL" and "ADD" marks on the dipstick.
11. Start the engine and let it run for a few minutes. Check the oil level again and make sure that it is still between the "FULL" and "ADD" marks on the dipstick.
12. That's it! You have now successfully changed the oil on your 1986 Honda Spree.
