WARNING
Disconnect the negative battery lead for safety before servicing any lights, electrics, or horns. Leave for 3 minutes before starting.
1. Locate the clock. The analog clock in the Peugeot 306 diesel is located in the center console, below the radio and above the air conditioning controls.
2. Remove the trim panel. The trim panel around the clock can be removed by gently prying it off with a flat-head screwdriver. Be careful not to damage the panel or the surrounding trim.
3. Remove the clock. Once the trim panel is removed, you will see two screws holding the clock in place. Use a Phillips-head screwdriver to remove these two screws and then remove the analog clock from the dash.
4. Disconnect the clock. There will be a wiring connector at the back of the analog clock. Disconnect this connector by pressing the release tab and pulling it apart.
5. Connect the new clock. Connect the wiring connector of the new analog clock to the wiring harness in the dash.
6. Mount the new clock. Place the new clock back into the dash and secure it with the two screws that were removed in the step 3 above.
6. Replace the trim panel. Replace the trim panel that was removed in the step 2 above.
