Tools Needed:
- Philips Head Screwdriver
- Flat Head Screwdriver
- Replacement Headlight Bulb (H4 Type)
Instructions:
1. Open the Hood:
- Locate the hood release lever inside your car, usually near the driver's left footwell. Pull the lever to release the hood.
- Lift the hood and support it using the hood prop rod.
2. Locate Headlight Assembly:
- On each side of the engine bay, you will find the headlight assembly behind the clear plastic cover.
3. Remove the Plastic Cover:
- Use a flathead screwdriver to gently pry open the plastic cover. It is held in place by plastic clips.
4. Disconnect Electrical Connector:
- Locate the electrical connector attached to the back of the headlight bulb.
- Press the release tab and detach the connector.
5. Remove Old Headlight Bulb:
- Twist the old headlight bulb counterclockwise to unlock and remove it from the housing.
6. Install New Headlight Bulb:
- Align the tabs on the new bulb with the slots in the housing.
- Gently twist the bulb clockwise until it locks in place.
7. Reconnect the Electrical Connector:
- Attach the electrical connector to the new headlight bulb.
8. Replace Plastic Cover:
- Snap the plastic cover back into place, making sure all clips are secured.
9. Test the Headlight:
- Turn on your vehicle's headlights and check that the new bulb is working properly.
10. Close the Hood:
- Lower the hood and release the prop rod.
- Double-check that the hood is securely latched.
*Please note:* If the headlight bulb needs replacing, use the same type of bulb (H4) to ensure compatibility and proper functioning of the headlight.***
