2. Remove the serpentine belt. The serpentine belt drives the power steering pump, so you will need to remove it in order to access the pump.
3. Drain the power steering fluid. There is a drain plug on the bottom of the power steering pump. Remove the plug and allow the fluid to drain into a catch pan.
4. Remove the power steering pump bolts. There are four bolts that hold the power steering pump in place. Remove these bolts and then lift the pump out of the car.
5. Install the new power steering pump. Place the new pump in the car and then insert the four bolts. Tighten the bolts until they are snug.
6. Reinstall the serpentine belt. Route the serpentine belt around the pulleys and then tighten the tensioner bolt.
7. Add power steering fluid. Add new power steering fluid to the reservoir until the fluid level is between the "Full" and "Add" marks on the dipstick.
8. Start the car and check for leaks. Start the car and let it run for a few minutes. Check for any leaks from the power steering pump. If there are any leaks, tighten the bolts until the leaks stop.
9. Reconnect the battery. Reconnect the battery and then test the power steering system. The power steering should now be working properly.
