Step 1:
- Park your vehicle on a level surface and turn off the engine.
- Engage the parking brake and chock the wheels.
Step 2:
- Open the fuel filler door and locate the fuel pump module access cover
- The access cover is typically located on the top or side of the fuel tank.
Step 3:
- Remove the access cover bolts using a wrench or screwdriver
- Once the bolts are removed, carefully lift the access cover off the tank.
Step 4:
- Disconnect the electrical connector.
- Use a flathead screwdriver to pry up the locking tab, and then pull the connector straight up.
Step 5:
- Disconnect the fuel lines
- Use a flare nut wrench to loosen the fuel line fittings, and then pull the fuel lines off the fuel pump module.
- Allow any fuel to drain into a suitable container.
Step 6:
- Remove the fuel pump module mounting bolts
- Use a socket wrench to remove the bolts that secure the fuel pump module to the fuel tank.
- Once the bolts are removed, carefully lift the fuel pump module out of the tank.
Step 7:
- Inspect the fuel pump module and replace it if necessary.
- If the fuel pump module is damaged or faulty, replace it with a new one.
- Reverse the steps to reinstall the fuel pump module and reconnect the electrical connector and fuel lines.
Note:
- The fuel pump module is located on the top of the fuel tank, inside the fuel tank access cover.
- The electrical connector and fuel lines are located on the top of the fuel pump module.
- Refer to your vehicle's service manual for specific instructions and safety precautions.
