Auto >> AutoSPT >  >> Engine

What is the balancer bolt specs on 1979 olds 403?

The balancer bolt specs for a 1979 Olds 403 engine are as follows:

* Thread size: 1/2-13

* Length: 3.5 inches

* Torque: 105 ft-lbs

It's important to use the correct bolt size, length, and torque when installing the balancer bolt to ensure proper engine operation and prevent damage to the engine.

Auto Repair
How do you replace the front turn signal bulb on a 1998 Buick Century? How do you remove the door panel on a 1992 Oldsmobile Delta 88 Royal?
Car Care
How does one go about hiring a car in Copenhagen? A Guide To The 8 Most Common Car Battery Types 7 Warning Signs of a Bad Alternator
Engine
Why do you have to pump the gas pedal every time first start your 85 buick regal after is has been sitting for an hour or two? What size engine does the 2009 Jeep Compass have?
Electric Car
Battery Breakthrough Gives Boost to Electric Flight & Long-Range Electric Cars Where is the speed sensor located on a 1997 dodge ram 1500 truck? Should the front drive shaft on a 2006 dodge 2500 turn while in 2wd?
Autopilot
Where is the idle speed control actuator on a 2000 Hyundai Accent? Day 8 Capability: Respond to unexpected vehicle maneuvers
Car Photos
What site is best for a car search? Is the 2005 Porsche Cayenne front wheel drive rear or four drive? What does the red triangle light on BMW mean?