* Oil filter wrench
* 13 mm wrench
* 24 mm wrench
* Oil drain pan
* New oil filter
* New oil pump
* Oil pump gasket
* RTV sealant
* Funnel
Instructions:
1. Park your Bronco on a level surface and turn off the engine.
2. Allow the engine to cool down for at least 30 minutes.
3. Locate the oil drain plug on the bottom of the oil pan.
4. Place the oil drain pan under the oil drain plug.
5. Use the 13 mm wrench to loosen the oil drain plug.
6. Allow the oil to drain completely from the oil pan.
7. Replace the oil drain plug.
8. Locate the oil filter on the side of the engine block.
9. Use the oil filter wrench to loosen the oil filter.
10. Remove the oil filter.
11. Apply a thin coat of oil to the gasket of the new oil filter.
12. Screw the new oil filter onto the engine block until it is snug.
13. Locate the oil pump on the front of the engine block.
14. Use the 24 mm wrench to loosen the oil pump mounting bolts.
15. Remove the oil pump mounting bolts.
16. Remove the oil pump from the engine block.
17. Clean the oil pump mounting surface on the engine block.
18. Apply a thin coat of RTV sealant to the oil pump gasket.
19. Place the oil pump gasket on the oil pump mounting surface.
20. Install the oil pump onto the engine block.
21. Replace the oil pump mounting bolts and tighten them until they are snug.
22. Add new oil to the engine through the oil fill cap.
23. Start the engine and let it run for a few minutes.
24. Check for any leaks.
