Auto >> AutoSPT >  >> Engine

Where is crankshaft position sensor located on a 1992 Buick Regal 3.1 and how do you replace it?

The crankshaft position sensor (CKP) is located on the front of the engine, near the bottom of the timing chain cover. It is a small, cylindrical sensor with a single wire connector.

To replace the CKP, you will need the following tools:

- Socket set

- Ratchet

- Extension

- Pliers

- New CKP sensor

Instructions:

1. Disconnect the negative battery terminal.

2. Locate the CKP sensor on the front of the engine.

3. Disconnect the wire connector from the CKP sensor.

4. Use a socket and ratchet to loosen the bolt that holds the CKP sensor in place.

5. Remove the bolt and pull the CKP sensor out of the engine.

6. Inspect the CKP sensor for damage. If it is damaged, replace it with a new one.

7. Install the new CKP sensor in the engine.

8. Tighten the bolt that holds the CKP sensor in place.

9. Reconnect the wire connector to the CKP sensor.

10. Reconnect the negative battery terminal.

The CKP sensor is now replaced.

Auto Repair
Checking steering joints for wear How do you remove a 1987 Harley Davidson starter motor?
Car Care
Your car uses too much coolant? What Causes Engine Clicking and How Do You Get Rid of It? What is function of clutch plate a Vehicle?
Engine
Where is the crankshaft sensor located on a 2002 Nissan Altima? What is the max RPM and hp for a 1979 Chevy 366 truck engine?
Electric Car
How do you replace the heater core in a 1996 Chevy truck? What size gas tank does a 1995 Chevy s10 have? 97 Cadillac Seville the guy you bought from said he used to listen his iPod in car where is connection at car?
Autopilot
What is the average Auto shop square foot? What are motorcycle wheel chocks?
Car Photos
Where is the temperature sensor on a Peugeot 407? Is a porche German car? Where is the Peugeot boxer speed sensor?