- Socket Wrench
- Socket Set
- Safety Goggles
- Replacement Starter
- Wrenches
- Screwdrivers
Instructions:
1. Disconnect the battery. This is to prevent any electrical accidents from happening while you are working on the starter.
2. Locate the starter. The starter is located on the passenger side of the engine, near the bottom.
3. Remove the bolts holding the starter in place. There are two or three bolts that hold the starter in place.
4. Disconnect the wiring from the starter. There are two wires that connect to the starter. One is the positive wire, and the other is the negative wire.
5. Remove the starter. Once the bolts are removed and the wires are disconnected, you can remove the starter from the car.
6. Install the new starter. Place the new starter in the car and tighten the bolts that hold it in place.
7. Reconnect the wiring to the starter. Reconnect the positive wire and the negative wire to the starter.
8. Reconnect the battery.
Once all the steps have been completed, ensure everything is tightly secured. Then start the car and test the new starter.
