Auto >> AutoSPT >  >> Engine

How do you reset service engine light on 2003 Mitsubishi eclipse?

To reset the service engine light on a 2003 Mitsubishi Eclipse, you will need an OBD-II scan tool. Follow these steps:

1. Turn on the ignition, but do not start the engine.

2. Connect the OBD-II scan tool to the diagnostic port, which is usually located under the dashboard.

3. Turn on the scan tool.

4. Select the "Service Engine Light" option from the menu.

5. Choose the "Reset" option.

6. The service engine light should turn off.

7. Disconnect the scan tool.

8. Start the engine.

If the service engine light turns back on, you may need to have your vehicle diagnosed by a mechanic to identify and repair the underlying issue.

Auto Repair
Have a Flat tire? Apt Tips for Tire Changing How do you replace the blower resistor on a 1998 Chrysler Town and Country?
Car Care
How to choose the best car rental place How do Diesel Engines Run Without Spark Plugs? Rivian Got a Tax Break on Their $5 Billion Texas Factory
Engine
Have a 2003 Camry and notice the power steering fluid is bit low spec saids dexron ii or iii which you have but your atf container has red in reservoir that the? How much gas is in the tank when fuel light comes on?
Electric Car
Where is the ecm relay for a 1989 mustang? Octopus Energy powers UK Ionity network Is it possible to put a ford 302 motor in Porsche 928?
Autopilot
What does the CB mean on a Honda motorcycle? What causes crank sensor problems?
Car Photos
Can you return a vehicle purchased yesterday and get your trade in car back? Does the 2002 ford explore xlt come with third seat? Where is the vin in a 1989 Jeep Grand Wagoneer?